EXERCISE MONITOR FUNCTIONS
With your Manual Magnetic Elliptical Trainer the single screen, 8 function
Exercise Monitor is set to start automatically when you begin to cycle.
However, it is possible to switch on the monitor by pressing the large
Enter Button at the bottom of the monitor. To save battery
consumption, the monitor will also switch off after it has been idle for
approximately four minutes.
Please refer to the leaflet supplied with the Exercise Monitor for all
operational functions.
DRIVE BELT and FLYWHEEL ALIGNMENT
It may be necessary at some stage to adjust the Drive Belt (56) on
your Manual Magnetic Elliptical Trainer. This can be achieved by removing
the 8 pre-fitted Machine Screws in the Chain Guards (21L & 21R).
Loosen the Flywheel Spindle Nuts (53) on both sides and adjust the two
10mm Alignment Bolt Nuts. Please take care to adjust each side equally
to ensure that the Flywheel is kept in alignment and that there is
approximately 10mm of FREEPLAY on the Drive Belt when correctly
adjusted.
10mm
56
57
53
Alignment Bolts
Assembly & Adjustments
Page 14
07MME
Manual Magnetic Elliptical Trainer
Содержание 07MME
Страница 2: ......
