BENSHAW RSi SG Series, Инструкция по эксплуатации

Страница: 58 / 218

Chapter 4 - Operation
4-2
4.1.2 Detailed Description
LCD Keypad Display
D R V T / K 0 . 0 A
0 0 S T P 0 . 0 0 H z
Displays Description
1) Parameter Group Displays the parameter group. There are DRV, FUN, AFN, I/O, and APP groups.
2) Run/Stop Source
Displays the control source for the drives run command.
K
: Run/Stop using FWD, REV buttons on keypad
T
: Run/Stop using control terminal input FX, RX
R
: Run/Stop using Modbus
O
: Run/Stop via option board
3) Frequency Setting
Source
Displays the source of the drive's frequency command.
K
: Frequency setting using keypad
V
: Frequency setting using V1 (0 ~12V) or V1 + I terminal
W:
Frequency setting using V1S (-12~ 12V)
I
: Frequency setting using I (4 ~ 20mA) terminal
P
: Frequency setting using Pulse input
R
: Frequency setting using RS-485, Modbus-RTU
U
: Up terminal input when Up/Down operation is selected
D
: Down terminal input when Up/Down operation is selected
S
: Stop status when Up/Down operation is selected
O
: Frequency setting via Communication Option board
J
: Jog terminal input
1 ~ 15
: Step frequency operation (except Jog)
4) Output Current Displays the Output Current during operation.
5) Parameter Number
Displays the parameter number. Use the
▲
(Up),
▼
(Down) key to move through the parameters.
6) Operating Status
Displays the operation information.
STP
: Stop Status
FWD
: During Forward operation
REV
: During Reverse operation
DCB
: During DC Braking
LOV
: Loss of Analog Frequency Reference (V1: 0~12V, -12~12V)
LOI
: Loss of Analog Frequency Reference (I: 4~20mA)
LOA
: Loss of Pulsed Reference Input
LOR
: Loss of Reference from Communications Option Board (Communication network fault)
Over Lap (flashing):
More than one digital input is programmed to the same function.
7) Drive Output Frequency/
Command Frequency
Displays the Output Frequency during run.
Displays the Command Frequency during stop.
►
2) Run/Stop Source
3) Frequency Setting
Source
4) Output Current
7) Drive Output Frequency During Run,
Command Frequency During Stop
6) Operating Status
5) Parameter Number
1) Parameter group