BENSHAW RediStart EXEXMVRMX3 Series, Руководство пользователя

Страница: 45 / 222

3.12.2 Display Cutout
3.12.3 Installing Display
The remote display is installed as follows:
•
Install the gasket onto the display.
•
Insert the display through the door cutout.
•
Insert the mounting clips into the holes in each side of the display.
•
Tighten the mounting clips until they hold the display securely in place. (Torque requirements are 0.7 NM or 6.195 in lbs).
•
Plug the cable into the display connector on the MX
3
card. See Figure 10 – Control Card Layout on page 27 for the connector location.
•
Route the cable through the enclosure to the display. Observe the wiring considerations as listed in Section 3.4.3 on page 21.
•
Plug the other end of the cable into the LCD display.
35
3 - INSTALLATION
63.50
[2.50"] 63.50
[2.50"]
38.50 [1.52"]
38.50
[1.52"]
127.00
[5.00"]
77.00
[3.03"]
Figure 21: Large Display Keypad Mounting Dimensions
Part # : KPMX3LLCD