Bender CC613, Руководство пользователя

Страница: 7 / 32

CC613_D00381_04_M_XXEN/11.2020 7
CC613 charge controller
2 Function
i
Local access to the charge controller
Local access to the charge controller is possible either as operator or as manufacturer. Further details are
described in chapter 5.1.1.
Operator access is possible via the http://192.168.123.123/operator:
- User name: operator
- Password: yellow_zone
The manufacturer can access the manufacturer area via the URL http://192.168.123.123/manufacturer:
- User name: manufacturer
- Password: orange_zone
i
The default passwords should be changed to prevent unauthorised access.
2.1 Intended use
The CC613 charge controller, hereinafter referred to as "charge controller", is the main component of a charg-
ing system. It is intended for use in electric vehicle charging stations, wallboxes or street light charging points.
The charge controller controls type 1 and type 2 socket-outlets as well as attached cables. It enables a setup
that complies with the requirements of current standards, e.g. IEC 61851-1 and IEC 62955.
2.2 Product features (depending on the variant)
• Charge controller in accordance with IEC 61851-1 (mode 3 charging)
• Master and slave operation configurable
– Setting up charging stations with two charging points: 1 charge controller as data gateway with
4G modem and 1 charge controller as slave without 4G modem
• Dynamic load management to optimally distribute the available power among all charging points
and signal the maximum power to the vehicle
• Residual direct current monitoring module (external RCD type A required), different cable lengths
can be selected
• Integrated emergency opener for actuator control (locking/unlocking) and monitoring of the 12 V
supply voltage
• Can be integrated in single- or three-phase systems up to 80 A
• OCPP 1.5 and OCPP 1.6 compliant with JSON, SOAP
• Supported mobile networks: 4G (LTE), 3G (UMTS) and 2G (GSM) with an integrated 4G modem
• 3 USB interfaces:
– 1 CONFIG interface for local configuration and installation of software updates
– 2 USB host interfaces
• Control Pilot and Proximity Pilot communication (acc. to IEC 61851-1)
• Configurable support for additional SCHUKO socket-outlets
• Meter interface: Modbus TCP and RTU
• External Modbus interface for remote control via energy management systems
• User interface modules for customer-specific applications (e.g. RFID, LED, antenna)
• Configurable 2-channel input/output extension interface for additional functionality
• Internal temperature sensor to reduce the charging current depending on the ambient tempera-
ture
• ISO 15118 Powerline Communication (PLC) for plug & charge and load management systems