Technical documentation
Rev. 02
Reactive Factor Controller CX plus
15
7 Indications on the display
The currently selected main menu is shown on the right
side of the display.
INFO
:
Step database
AUTO
:
Control is active: Steps are switched on and off
automatically.
MANUAL
:
Manual operation: Steps can be switched on and off
manually.
SETUP
:
Setup menu
ALARM
:
Alarm memory: The last 10 alarms can be shown here.
The current COS PHI is shown in the top menu level in the
first line of the display. The small
i
resp.
c
indicates, if the
COS PHI is inductive or capacitive. The codes for the
individual sub-points are shown in the submenus.
The settings and measurement values (in the middle) with
the respective abbreviation (on the left) and the units (on
the right) are shown in the second line of the display. In
case of an alarm, a message will be shown here. All
possible messages are listed and explained in the table on
the next page.
Active switching outputs are shown in the bottom line. If one step was
identified as defective (three unsuccessful switching operations), the
respective step symbol starts to flash. The step symbol of the selected
step is flashing in the step database and in the setup menu.
NT
:
2
nd
target COS-PHI is active
EXPORT
:
Export (feeding back) of active power
ALARM
:
Flashes when there is an alarm message
