Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
EZ18, EZ24, EZ34 OM
MN-1317EN
5
Melting and Filling
1. Completely cover the heating element with
shortening. There are two ways to do this:
•
Pre-melt some shortening in a pan on the
stove and pour it into the kettle to cover
the element.
•
Pack solid shortening tightly around the
heating element and bulbs. Do not leave
any air spaces. Cover the heating element
at least 2”/5 cm. (See Figure 1-6)
WARNING
Air spaces can cause the shortening to
overheat and catch on fire.
2. Install the cube melter in the kettle, opposite
the heater head. Push the cube melter through
the shortening so its legs rest on the bottom
of the kettle. (See Figures 1-7 & 1-8.)
Figure 1-6. Packing Solid Shortening in the
Kettle.
Figure 1-7. Cube Melter
Figure 1-8. Installing the Cube Melter.
3. Position the EZ Melt near the fryer.
4. Install the supply hose. Follow these steps:
a. Attach the hose to the pump outlet by
hand-tightening the hose connector.
b. Mount the nozzle of the hose on the edge
of the fryer kettle with the opening
inside the kettle.
