Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
6
MN-1318EN
EZ18, EZ24, EZ34 TS
THE SHORTENING DOES NOT FLOW FREELY THROUGH THE FILTER
SYSTEM
Possible Causes
What To Do
The hose is crimped.
Straighten the hose.
Solid shortening is building up inside the hose and
pump
Filter shortening at a higher temperature.
WARNING
To avoid being burned, before doing any of the
following, turn off the EZ Melt and allow the
shortening to cool.
The hose is clogged with shortening.
Soak the hose in warm or hot water to help release
the clogged shortening. Hang it up and let it dry
before you use it again.
The drain tube is clogged with solid shortening.
Remove the drain tube and soak it in warm or hot
water to help release the clogged shortening.
The pickup tube is clogged with residue.
Remove the pickup tube and clean it.
THE PUMP MOTOR WILL NOT RUN
Possible Causes
What To Do
The connection of the power cord to the power
source is faulty.
Make sure the power cord is fully plugged in to a
proper power source.
The circuit breaker has been tripped.
Press the reset button.
If the problem persists, consult your Belshaw
dealer, or call Belshaw.
WARNING
Before doing the following, turn off the
machine, allow it to cool, and disconnect it
from the power source.
The power switch is defective.
Repair or replace the power switch.
The motor is defective.
Repair or replace the motor.