Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
10
MN-1317EN
EZ18, EZ24, EZ34 OM
2 Cleaning
WARNING
Be careful with hot shortening. Always wear
proper protective gear (face shield, apron and
gloves) when filtering, disassembling and
cleaning
Clean the EZ Melt after every use. Follow these
steps:
1.
Turn on the heat and the pump.
2.
Press the foot pedal to pump shortening out
of the EZ Melt and into a metal container or
fryer kettle.
3.
When you cannot pump any more
shortening out of the EZ Melt, release the
foot pedal. Turn off the heat and the pump.
4.
Disconnect the EZ Melt from the power
source.
5.
Disconnect the filter hose assembly while
still hot and drain any remaining shortening
back into the filter kettle to prevent
shortening from hardening in the hose.
6.
Store the hose hanging vertically with the
lower end of the hose in a metal container to
catch any shortening that may drip.
7.
Allow the shortening in the EZ Melt kettle
to cool to 115
°
F/46
°
C.
WARNING
Hot shortening can cause serious injury.
8.
Clean the EZ Melt filter. Follow these
steps:
a. Allow the filter assembly to cool to the
touch.
b. Lift off the filter assembly, holding it by
the frame.
c. Invert the filter assembly over a sink or
garbage can and shake the sediment off
of it.
d. Unsnap the filter to remove it from the
filter frame.
e. Rinse the remaining shortening and
crumbs off of the filter.
WARNING
Thoroughly clean and dry the floor if
shortening, water, or other materials are
spilled. Materials spilled on the floor may
cause serious injury and loss of life.
9.
Remove the cube melter.
10.
Loosen the two fasteners at the back of the
heater head, lift it off the kettle and place it
in a clean safe place. The foot valve and
cord will unsnap from the frame. See Figure
2-1.
