9-3. Inserting a new bulb
Replace halogen lamp only with type JA--24V 60W cbtaainable through your local dealer.
IMPORTANT
(1) At inserting the bulb, make sure that the projection of the bulb holder and the cut-out of the bulb are
aligned. Misalignment will cause an improper light pattern.
Cut-out of bulb
Projection
of the bulb holder
< Fig.6 >
< Fig.7 >
Connect firmly
(2) Close the bulb retaining spring. Make sure to place the springs behind the hook. See Fig.6
(3) Firmly attach wire connectors. See Fig.7
< Fig.8 >
< Fig.9 >
< Fig.10 >
Light bulb cover fixing screw
Cut out
Reflector cover
fixing gap
Light bulb cover fixing screw
Thread hole
Push and tighten until it clicks
Be careful not to pinch the wires
9-4. Attaching the reflector cover
(1) Insert the cut-out of the reflector cover into the gap at the handle (right). See Fig.8
(2) Be careful not to pinch the wires when attaching cover. See Fig.9
(3) Hold the reflector cover and tighten the screw by turning it clockwise by 90 degrees.
( From mark to mark.)
Make sure to tighten it by pushing it forward until it clicks. See Fig.10
-10-
