[P]5 MACKEREL AND SQUID FISHING PROGRAM
This program is used for trolling mackerel and is also used
for squid fishing.
Jig length
is not used in this program
because line is hauled up to
Zeropoint
each time motor
starts. Every time lines heads down the
Fishing depth
is
reduced, if desired, to a minimum Fishing depth.
Two new features are used...
•
Deep reduction[P]5[PP]
is the reduction of the
Fishing
depth
for each time the line has been hauled up to
Zeropoint
. This attract the fish against shallower water,
which allows for faster catch retrieval.
•
Minimum depth.
Reducing the
Fishing depth
to the
Zeropoint
would not work well.
Minimum depth
is the
shallowest
Fishing depth
that will be used.
Diagram 5
Mackerel / Squid program
Time
Depth
Depth reduction
Minimum depth
[P]5
Pictures
Min
Max
Factory
Step
Unit
Navigation
Line out
0
999
-
1
M/Fm/Ft
Main screen
Fish program
Makrillfiskeprogram
[P]5
Depth reduction
1
10
2
1
M/Fm/Ft
[P]5 [P]
Minimum depth
0
999
5
1
M/Fm/Ft
[P]5 [PP]
Från Menu
[E]
Depth pause
1
10
1
1
M/Fm/Ft
[E2 P]
Screens in Mackrel / Squid program
Example of wheel behavior with following settings…
•
Fishing depth
is 50 meters.
•
Depth reduction
is 5 meters.
•
Minimum depth
is 30 meters
When
[A]
uto is pressed.
• The machine releases to 50 meters. Brakes up and then pulls up the entire line to Zeropoint.
• Next release will be to 50-5 = 45 meter. Brakes up and then retracts the entire line again.
• Ex will continue reduce the
Fishing depth
until…
• Reduction of
Fishing depth
gets above 30 meter. Reduction is stopped and 30 meter will be set as
Fishing depth
for all further fishing, until next press on
[A]
uto button.
Programming of Mackerel fishing…
• Press
[P]
rog and make sure top row shows "
Fish program
". Change with button
[3]
and
[6]
until row 3
shows "
Mackerel fishing
“.
• Press
[P]
rog, set
Fishing depth
.
• Press
[P]
rog, set
Depth reduction
.
• Press
[P]
rog, set
Minimum depth
.
• When done, press
[P]
rog or
[E
]nter for
Main screen
In
Mackerel fishing
, the
Catch depth
is not shown, but
Catch registration
on
High load,
and
Low load
is still active in order to enter
Catch mode
which gives more options to variate motor power and speed.
For available
Catch Detection Sensors
in this program, see Table 1 on page Machine - 4
The diagram shows theoretically how the sinker is drawing
on an echo sounder image, with the depth of the vertical
axis and the time on the horizontal.
