GUIDE TO INSTALLATION AND OPERATION
HDA-1911/1931 |
9
the latter case, an adapter will also be required for the rear panel, as described above. These adapters extend the
height of the Densité-2 devices so that they will fit into the slots of the 3 RU Densité-3 frame.
Card adapters:
There are 3 different types of adapters available,
depending on the Densité 2 card geometry, so be
sure to order the adapter designed to fit the HDA-
19x1 card.
Densité 3
– EXT B
Install the adapter on the HDA-19x1 as follows:
1. Fit the top edge of the card into the holding
slot along the bottom edge of the adapter.
2. Align the holes in the top of the card with the
holes on the adapter, and secure them
together with the two provided screws and
lock washers, as shown in the figure.
Rear adapters:
3-RU rear module adapters are available for Densité-2
rear panels:
o
DENSITE-SRP-3RU for single-slot-width rear panels
o
DENSITE-DRP-3RU for double-slot-width rear panels
Install these as follows:
1. Position the adapter at the top of the empty
slot(s) on the rear of the frame.
2. Use the captive screw in the adapter to
fasten it securely in position.
