GUIDE TO INSTALLATION AND OPERATION
16
| HDA-1911/1931
3.4 Remote control using iControl
The operation of the HDA-19x1
may be controlled using Miranda’s iControl system.
This manual describes the control panels associated with the HDA-19x1 and their use.
Please consult the iControl User’s Guide for information about setting up and operating iControl.
Exception:
At the time of printing, the HDA-19x1 was not supported by iControl Solo
In iControl Navigator or iControl Websites, double-click on the HDA-19x1 icon to open the control panel.
3.4.1 The iControl graphic interface window
The basic window structure for the HDA-19x1 is shown in figure 3.2. The window identification line gives the card type
(
HDA-1911 or HDA-1931
) and the slot number where the card is installed in its Densité frame.
Figure 3.2
HDA-1931 iControl graphic interface window:
There are three main sections in the window itself, shown in Figure 3.2:
1.
The top section displays icons on the left. These icons report the
status of some parameters associated with this HDA-19x1. Figure 3.3
shows the three icons that appear.
Move the mouse over an icon and a status message appears below the
icon providing additional information.
If there is an error, the error status message appears in the message
area without mouse-over.
If there are multiple errors, the error messages cycle
The icon whose status or error message is shown is highlighted
with a mauve background
Icon # 1
2
3
Figure 3.3
iControl Status Icons
1
2
3
