GUIDE TO INSTALLATION AND OPERATION
20
| HDA-1911/1931
Figure 3.7
Output panel
– Single
Channel Operating Mode
3.4.5 The
Output
panel
This panel controls the optical
output functions (when
equipped; see the Status tab)
related the HDA-19x1 output:
Output Config
If an optical output is available,
use the radio buttons to
independently turn the two
optical outputs OFF or ON:
Optical output is only
available for rear panels
with a Fiber I/O
connector and an
installed single or dual
output (TX) cartridge
Optical output A, can
only carry channel A
On an HDA-1931, optical
output B can carry
Channel A when the
Operating Mode is set to
Single Channel (see the
Input tab), or it carries
Channel B when the
Operating Mode is set to
Dual Channel
On an HDA-1911, only optical output A can be configured. With a dual output (TX) cartridge, channel A is made
available at both optical outputs A and B
MSB Output
Use the radio buttons to select which of the two channels in the HDA-1931 will be sent to the Monitoring Switching
Bridge (if present) in the Densité frame.
This does not appear on the HDA-1911 as there is only one channel and as such, no choice is necessary.
Figure 3.8
Output panel
– Dual
Channel Operating Mode
