Belarus 1025/1025.2/1025.3
Section E. Preparation for operation
E12
Features of tractor when operating
rear PTO driven machines
General recommendations:
а
) before ganging up the machine with
tractor, make sure rear PTO control is
properly adjusted;
b)
у
mount and reliably fasten required
(6-, 8 or 21- splined) PTO drive end,
and switch on corresponding to it
rotation speed drive, for 6, 8-splined
face end set 540 rev/min, and for 21-
splined drive end —1000 rev/min.
To replace PTO drive end perform the
following operations:
1. Unscrew two bolts and take off cap (1).
2. Unscrew four nuts (3) and take off
sheath (2).
3.
Unscrew six bolts (4), take off plate (6)
and pull out drive end (5).
4. Put another drive end inside grooved
opening and install plate (6).
5. Assembly other parts in the order
reverse to disassembly.
c) grease shaft and tube of the
telescopic gimbal drive. Put joint of
the gimbal drive on the PTO drive
end, properly fasten it in the fixing
groove. Make sure yokes (1) of
intermediate (telescopic) shaft have
their eyes (2) aligned in one plane.
Failure to observe this requirement
causes overloads of gimbal drive
and PTO;
d) put in place sheath of an agricultural
machine cardan shaft;
