40
41
Quick Start Guide
EUROLIGHT LED FLOODLIGHT BAR 240-8 RGB
The device can be controlled in the following ways:
1.
Master/slave
2.
DMX control
Master/Slave control
1.
Connect the device(s) with DMX cable. Note: In order to prevent interference, connect less than or equal to 17 units at one time.
2.
Master/slave mode will be automatically activated.
3.
Specify host mode, and set the other units to SLAVE1/2/3/4/5 and all slaves will follow (Refer to Display Functions table for
SLAVE mode details)
Master (Host) mode:
S L A V E
M O D E
⟶
M A S T E R
The host also chooses performance mode or additional audio control:
S H O W
M O D E
S H O W 1
⟶
S H O W 4
DMX control
To use a DMX controller to control the lights, first set the DMX address code (the address code range is between 1-512) so that the lights
can receive the DMX signal.
1.
Press the MENU button and select the "DMX Address" menu option.
2.
Press ENTER button to enter. Using DOWN/UP to select DMX address code, the factory value is "Address 001".
3.
After the address code is set, hold down the ENTER key to save.
D M X
A D D R E S S
⟶
A D D R E S S
0 0 1
4.
Connect the output port of the controller to the DMX input port of the first device, and connect the DMX output port to the DMX
input port of the second device, and so on, until all slaves are connected.
IN
OUT
IN
OUT
IN
OUT
2
3
120
Ω 1 W
DMX-Controller
Controlling the Device
DMX Connection terminal device (Loop connection)
During the installation process, if the signal line is laid a long distance, or in a noisy environment, such as a dance hall, it is recommended
to use a DMX terminal (loop connection). This can reduce any interference to the digital control signal by electrical noise.
The DMX terminator consists of a simple XLR connector with pin 2 and 3 connected to a 120 Ω resistor. Please insert the terminal into the
XLR output port of the last device. Refer to the following picture:
