Behncke Control 1.3, Руководство по эксплуатации

Страница: 26 / 60

Control 1.3 Swimming Pool Control Unit
Operation
24
The control function is switched on and off by tapping on the left ON/OFF button. The button
turns green when the control unit is switched on. The button turns blue when the control unit is
switched off.

AUTO/CONTINUOUS:
The control unit switches between the automatic (filter running time according to switching
times) and continuous operation mode by tapping on the central button. The button turns blue in
automatic mode. The button turns orange in continuous operation mode.

SETTINGS:
The user accesses the settings menu by tapping on the right button with the screwdriver symbol.

DATE/TIME:
The day, date and underneath the time are displayed in the top right-hand corner of the start
screen

FAULT MESSAGES:
If there are any fault messages, these are indicated by a red warning triangle in the top left-hand
corner. The user can call up the fault messages by tapping on the warning triangle.

STATUS SYMBOLS (filter pump, fresh water, auxiliary heating, solar heating):
Individual status symbols found to the left of the date are only displayed if the corresponding
peripheral devices and their functions have been selected. A grey symbol indicates that the
corresponding peripheral device is not currently active. The coloured symbol indicates the active
status of the peripheral device. The colour of the pump symbol also shows the current speed.
The following symbols are available:
o
Green, one wave: the pump is running at low speed (ECO)
o
Blue, two waves: the pump is running at normal speed
o
Orange, three waves: the pump is running at maximum speed
o
Blue, with an exclamation mark: the pump is in FORCED ON mode at normal speed
o
Red, with an exclamation mark: the pump is in FORCED OFF mode and therefore stops

TEMPERATURE:
The water temperature and the collector temperature/outdoor temperature are displayed in the
middle at the bottom of the screen. T
he collector temperature is only displayed if “Solar 
sensor available” is set. The water temperature is only displayed if “Heating  sensor available”
is set.

MEAUREMENT & CONTROL TECHNOLOGY:
The measurement and control technology measurements are displayed below the temperatures.
These are only displayed if the measurement and control technology is connected and the
inputs for the measurement and control technology have been set.