Beef Eater signature plus, Руководство по сборке и эксплуатации

Страница: 11 / 36

11
ASSEMBLY INSTRUCTIONS FOR TROLLEY
ASSEMBLY INSTRUCTIONS FOR TROLLEY
Before You Start
Note the tools you will need before you begin�
Check for damaged or missing parts, and consult your
retailer if necessary�
Many components and panels are covered with a protective
sheet of plastic� You will need to remove this plastic covering
from all surfaces, especially where two panels join� It is
a good idea to leave some plastic on the panels during
assembly to protect the stainless steel during the assembly
process� Ensure however that all plastic covering is removed
on completion�
Always assemble on a clean, smooth, flat working surface
that will not scratch the surface of the stainless steel�
1) Fit The Fixed Castors
Fit the fixed castors into the holes in the bottom of the base�
At this step, use only two Allen head screws, washers and
nuts for each castor in the positions shown� The two outside
screws will be put on in step 3�
Spanner/wrench tighten immediately�
2) Fit The Rotating Castors
Fit the rotating castors into the holes in the bottom of the
base� Again, use only two Allen head screws, washers and
nuts for each castor in the positions shown�
Spanner/wrench tighten immediately�
3) Fit The Right And Left Side Panels
Use 5 Allen head screws, washers and nuts on each panel�
You may find it easier to lay the cart on its side for this step�
Only hand tighten at this stage - You will wrench/spanner
tighten at a later step�
Allen Key Adjustable
spanner/
wrench
Note lip
ends here
Phillips head
screwdriver
The right side has holes
for the gas hose