Beef Eater signature plus, Руководство по сборке и эксплуатации

Страница: 17 / 36

Replace The Drip Plate
Push the rear drip plate tabs back into the slots at the back
of the side burner body, and secure the front of the drip plate
with the screw removed earlier�
Secure All Joints And Leak Test
The gas leak testing procedure should be conducted every
time a gas cylinder is refilled and reconnected to the
appliance, or after any new gas connection is made. Never
use a naked flame to check for gas leaks.
In a small container, mix up a solution of water and
detergent or soap� Mix the solution well�
Make sure that the gas supply valve on the gas cylinder or
the shut off valve on the supply line is turned on� Make sure
that the gas control valves on the appliance are all turned off�
Using a brush or spray bottle apply the solution to the gas
line and each joint in the gas line, including the hose and
regulator�
Bubbling of the solution will indicate that there is a leak
present� Re-tighten or re-seal any joints that are leaking�
If a leak persists contact your distributor for assistance�
20) Finish Screwing In The Barbecue
The barbecue should be secured using 4 Allen head screws,
washers and nuts, as shown� If you have a side burner, the
right side of the barbecue will already be secured�
17
ASSEMBLY INSTRUCTIONS FOR TROLLEY
21) Fit The Dress Fascia To The Drip Tray
Screw the dress fascia to the drip tray using the small
Phillips head screws, washers and nuts packed with the
fascia�
22) Slide The Drip Tray Into Place
Ensure the drip tray slides along the top of the tracks
underneath the barbecue�
Now tighten all remaining screws and your assembly is
complete.
ASSEMBLY INSTRUCTIONS FOR TROLLEY