Beckhoff KL8001, Документация

Страница: 11 / 47

Product Overview
KL8001 and KL9060 11 Version: 2.0.0
Flashing Code
If there is a fieldbus error, the stop LED indicates a flashing code that describes the fault more accurately:
The LED flickers for about 2 seconds before starting the error output. After a clearly visible pause, the error
code is indicated through slow flashing, and the error argument is then indicated after a further pause. The
following table allows you to determine the error more precisely with the aid of these two items of
information.
Code Argument Description Solution
1 0 No rated current set: both the two rotary switches and
• the register PR33 are zero ( single-phase analysis
[
}
26] not active) or
• at least one of registers PR33, PR39 or PR45 is
zero (single-phase analysis is active)
• Use the rotary switches [
}
10] to set a rated
current, or
• enter values for the rated current in
registers PR33 [
}
34] , PR39 [
}
34] and
PR45 [
}
34] .
2 n Communication with the nth ADC is faulty Contact your supplier.
3 n Communication with the n
th
Hall sensor is faulty
Note
Changing the terminal registers
ü
To ensure that the new values are applied to the measuring unit after the terminal regis-
ters have been changed, you have to perform:
a) a power-off reset (switch the terminal off and back on again) or
b) a software reset [
}
33] (via the command register)!