BEAMEX MC6-Ex, Руководство пользователя

Страница: 17 / 116

About MC6-Ex - Hardware 9
I
NTERNAL
B
AROMETRIC
P
RESSURE
M
ODULE
The optional Internal Barometric Pressure Module is located inside MC6-Ex. It
has a venting hole on the back side of MC6-Ex. To ensure valid barometric
pressure measurements, do not plug the venting hole.
M
EMORY
MC6-Ex maintains data very much like personal computers. Data is saved on a
solid state memory that does not need any power to maintain its state. Solid
state memory is shock-proof so the data is not lost when the calibrator is trans-
ported. Also, you can safely save a large amount of instruments, calibration
results and data log results.
Available memory can be used for anything that requires it (e.g. instrument da-
ta, calibration results etc.).
D
ISPLAY
MC6-Ex has a backlit 640 × 480 pixel 5.7" TFT touch screen display. Use the
touch screen with your fingers, gloves on or off. Optionally, use a stylus meant
for touch screen use.
See also brightness settings in Part 8, Settings .
F
RONT
P
ANEL
LED
MC6-Ex's Light Emitting Diode (LED) indicates battery/charging status as fol-
lows:

When charger is connected and charging is in progress, the LED flashes
approximately once every second.

The LED is constantly lit when the charging of the batteries is ready
(with charger still connected).

When battery charge level is low, the LED is lit for a second in approx.
10 second intervals.
Venting hole of the Internal Barometric Module.
Note.
The Internal Barometric Pressure Module is not located in the
space reserved for Internal Gauge Modules, so you may have
both a barometric module and up to two gauge modules in your
MC6-Ex.
Warning!
Using sharp tools such as a screwdriver on the touch
screen may damage it. More warnings in Appendix.
Note.
When batteries have capacity enough to continue working with
MC6-Ex, the LED is not lit during normal operation.