Beam RemoteSAT RST100B, Инструкция по установке и эксплуатации

Страница: 23 / 40

23
Making a phone call
Logging on to Iridium Network
With the power turned on, the RST100B will attempt to register with the Iridium
network. The Signal LED uses colours to indicate how strong the Iridium signal is at your
location.
Signal LED colour Signal strength definition
Green Strong
Orange Acceptable
Red No signal, no calls possible refer to
“Troubleshooting” section
In most cases the indicator will show green after a short period of approximately 15
seconds – orange indicates an acceptable but marginal signal strength.
If the indicator remains solid red, there is a problem with the installation
and/or the SIM card – calls cannot be made or received. To resolve this
situation refer to “Troubleshooting” section of this manual.
Making a phone call
To successfully make a call on the Iridium network, you need the following:
• Dial tone on the telephone handset
• Call LED must shine green or orange continuously.
Continue to make your phone call as you normally use a traditional phone, noting any
dialling prefix instructions advised by your service provider.
Once you have entered the phone number you will hear progress pips from the Iridium
network. It can take up to 30 seconds for the Iridium network to connect a call, so a
pause at this stage is not unusual.
You will shortly hear the called party end ringing, or hear a busy tone and voice message
indicating why your call was not possible. When the other party answers the Call LED
will change from steady orange to flashing orange, indicating ‘call in progress’. This is a
normal operating procedure.
To end the call, hang up the handset. The Call LED light will then turn off.