19
Medical Gas Central Alarm - Medipoint 125 Digital Alarm
4233500107.03
Press the ENTER
key or press anywhere on the screen
away from the NUM-PAD to remove the NUM-PAD.
3.4.3 Panel ID:
This field sets the alarm ID number used for identification
within an alarm network. All alarms connected within a
network must have a unique ID number.
Press the up arrow to increase the ID number, down
arrow to reduce the ID number.
3.4.4 Language:
Press on the down arrow to show the drop down list.
Pressure on the language of choice to select.
Note - Currently English only is available.
3.4.5 Relay Mode.
This field sets the slave relay output condition to either
normally open or Line Contact Monitoring (LCM), see
section 2.2.7.
Press on the left or right arrow to switch between the
two options.
3.4.6 New Password & Confirm.
This field sets the new password for accessing the setup
menus screens and data log screens.
Press on the first field (New password), the num-pad will
appear.
Use the num-pad to enter the new numerical password.
Press the TAB
key, or press the next field to go to
the next field (Confirm). Use the num-pad to enter the
password again.
Press the ENTER
key or press anywhere on the screen
away from the NUM-PAD to remove the NUM-PAD.
3.4.7 Input Panel.
This option determines if the alarm panel is the master
panel on the network. There should only be one master
alarm panel on the network. The master panel shall be
set as the highest alarm ID number. The default setting
is ticked.
Select the tick box to set accordingly.
3.4.8 Master Mute.
This option determines if the master mute function as
per HTM is activated on this panel.
If the master mute is active and the mute button is
pressure during a fault condition, all fault conditions
stop flashing on all alarm panels on the network. This
is to indicate to all areas on the network that the fault
has been detected and being attended too. The default
setting is unchecked.
Select the tick box to select accordingly.
3.4.9 Graphics Dark Mode.
This option determines the alarm panel main screen
colour sceme.
Select the tick box to select accordingly, which will toggle
between the following typical main screen.
Typical dark mode view
