60
60
Following our example, type "3" (For Power/DCD) to send String 1 out
upon power-up or loss of DCD.
NOTE:
If you select "4" (For Manual), the programmable string will only
be sent manually by typing
Control-U
for String 1 or by typing
Control-V
for String 2 when the Telplex is in Access Local Modem mode (multi-
drop units) or Local mode (standard units). Regardless of the selection,
String 1 will always be sent when the active terminal sends
Control-U
and String 2 will always be sent when this device sends
Control-V
from
either mode.
The Telplex will respond with:
+--------+------------------------------------------+----------+
| String | Programmable String | Send On: |
+--------+------------------------------------------+----------+
| 1 | ATDT15551234567^M | Power/DCD|
+--------+------------------------------------------+----------+
| 2 | | Manual |
+--------+------------------------------------------+----------+
String 1.......................1 String 1 Send On........3
String 2.......................2 String 2 Sent On........4
Enter Number 1-4 to Change or X to Exit:
NOTE:
String 1 will be sent out of the composite port whenever the
SELECT
switch is pressed for more than three seconds while the
Telplex is in System/Local mode or in an idle state regardless of the
condition selected above.
You may now enter another request or "X" to return to the main
configuration menu (see
Section 5.1
).
Содержание Telplex TX102
