Page
23
Login
Setup
Menu
Menu 3: Network Login
Access
Control
Manage
Users
Menu 4: Network Manage User
Select 7, from the Network Configuration Menu,
allows the admin user to enable or disable the
Access Control, Manage Users, Radius, and
TACACS configuration. Depending on the firmware
installed the Login Setup menu may be slightly
different than what is shown.
Access Control..................1
Manage Users....................2
Direct Port Connection..........3
Radius Configuration............4
TACACS Configuration............5
Dial Back Configuration.........6
Exit............................X,CR
Select 1, from the Login Setup Menu,
this security
feature allows the admin to enable or disable
usernames and passwords for both network and
serial port access.
Telnet Login Prompt Enable/Disable..1
Serial Login Prompt Enable/Disable..2
Modem Login Prompt Enable/Disable...3
Select 1),
for
Telnet
login
Type
“Y”
to enable Login Prompt,
Type
“N”
to disable prompt.
Press “Enter” to keep same setting
Select 2),
for
Serial
login
Type
“Y”
to enable Login Prompt,
Type
“N”
to disable prompt.
Press “Enter” to keep same setting
Select 3),
for
Modem
login
Type
“Y”
to enable Login Prompt,
Type
“N”
to disable prompt.
Press “Enter” to keep same setting
Login prompt for telnet is........Enabled
Enable ? (Y/N), CR for no change) :
Login prompt for serial is........Disabled
Enable ? (Y/N), CR for no change) :
If the login has been enabled you will get a prompt similar to the following:
The default user and password is
root
and
baytech
, all lower case.
NOTE: Modem hangs up and Pauses for 10 seconds after 3-login failures.
DS62 login: root
Password:
Select 2, from the Login setup Menu,
to allow the administrator to add/delete users and change
their passwords for multiple users. Usernames and passwords are case sensitive and alphanumeric.
The root user can not be removed. Select Manage User and the Unit displays the following:
NOTE:
The port access mentioned in the User Management Menu below is not used in the
MSP series.
User Management Menu
To change user password or port access, enter number of user.
To add/delete user, select appropriate menu choice.
SNMP V3 requires passwords that are between 8 and 31 characters long
Enter request, CR to exit menus.
A)...Add user
1)...root
Login prompt for modem is.........Enabled
Enable ? (Y/N), CR for no change) :
