Page
29
Network
Port
Configuration
Menu 7: Network Port Configuration
IP
Address
Subnet
Mask
The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the RPC to
determine whether to send a packet directly to the client or to a gateway. The Subnet Mask consists of
four bytes, each byte ranging from 0 to 255.
This parameter must be programmed before the MSP
can be accessed through the network
.
The IP address is the network address assigned by your network manager for your network. The IP
Address consists of four bytes, each byte ranging from 0 to 255.
This parameter must be programmed
before the MSP can be accessible via the network.
NOTE:
There should be no active connections while configuring the MSP. The unit should be
reset upon completion of configuration.
Select 8), from the Network Configuration
Menu,
this menu is used to change the
network configuration options such as the IP
Address, Subnet Mask, Gateway, DHCP,
and Telnet; all of which are necessary during
initial startup. The
Connection
Inactivity
Timeout
allows you to enable/disable
whether the firmware will end your session
or “times out.” The default is 1 hour, but
when disabled there is no set time out.
Disabling the
Carriage Return Translation
allows you to bypass all unnecessary
carriage returns, and it will send you straight
to the next “end of line.” The
DHCP,
Telnet, SSH,
options is to enable or disable
these functions. SSH host key Generator
allows the user to generate a host key which
is used in the SSH encryption process.
IP
Filter
allows or blocks specific IP
Addresses,
SNMP
provides a message format for communication between a computer and your devices,
and
Web Server
Configuration allows web access and sets up options for each.
Network setup :
Ethernet Address................ 00:C0:48:00:01:FD
IP Address...................... 70.150.140.89
Subnet Mask..................... 255.255.255.224
Default Gateway................. 70.150.140.65
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Enabled
Break Length (msecs): 350
DHCP is Disabled Telnet is Enabled SSH is Enabled
SSH host keys are set to factory default
IP Address........................1
Subnet Mask.......................2
Gateway Address...................3
Inactivity Timeout................4
Carriage Return Translation.......5
Break Length......................6
DHCP Enable/Disable...............7
Telnet Enable/Disable.............8
SSH Enable/Disable................9
SSH Host Key Generation...........10
IP Filter Configuration...........11
SNMP Configuration................12
Web Server Configuration..........13
Exit..............................X,CR
Enter Request :
IMPORTANT:
For network access, you must configure the IP addresses, Subnet Mask, and
Gateway Address. A unit reset must be performed for network changes to take effect.
Select 1,
to enter the IP Address. Failure to enter the address in the decimal form causes the unit to
display the following until it is entered correctly.
Default Module IP Address is 0.0.0.0.
Enter IP address in dotted decimal form :
Select 2,
to enter the Subnet Mask followed by <cr>. Failure to enter the address in the decimal form
causes the unit to display the following until it is
entered correctly.
Default Subnet Mask is 0.0.0.0.
Enter Subnet Mask in dotted decimal form :
