Bayrol NATURALLY SALT Salt Relax POWER, Руководство по эксплуатации и установке

Страница: 6 / 44

3 Installation
6
In order to supply the Salt Relax POWER with power via a filter control as shown in the diagram above, the mains power plug supplied can be
dismantled as shown below.
Attention:
Connection of the Salt Relax POWER in this way must be performed by a specialist technician with in-depth knowledge of the
installation of electrical and electronic devices!
When connecting the power supply cable of the Salt Relax POWER to the filter control, it is imperative to follow the instructions
(connection diagram) provided with the filter control.
3.2.2 Salt Relax POWER as filter control
As standard, the Salt Relax POWER can be used as a controller for the filtration pump; please refer to the section Filtration. In this case, the mains
power plug of the device is connected to a water-protected mains socket with a 30 mA residual current circuit breaker.
See also the information in the chapters Filtration, Configuration and Connecting terminals.
3.3 Connecting the chlorine production cell
When connecting the cell supply cable to the control unit, make sure that the cable is inserted firmly at the points provided, with no loose contact. The
cap nut of the plug-in connection must be securely tightened. If this is not the case, there is a risk of overheating at this connection.
Also insert the second, thinner cable (gas flow sensor) of the chlorine production cell carefully into the connection point provided (see Connections
and fuses on the Salt Relax POWER).
3.4 Connecting the temperature sensor
The temperature sensor cable is routed into the Salt Relax POWER through the cable grommet mounted at the factory on the underside of the
housing front cover (see "Installing a cable grommet") and connected as described.