Bayrol NATURALLY SALT Salt Relax POWER, Руководство по эксплуатации и установке

Страница: 29 / 44

5 pH option
29
Electrical connection of the pH pump in the Salt Relax POWER:

Disconnect the Salt Relax POWER from the mains. It is not enough to simply switch the device off.

Remove the front cover of the Salt Relax POWER (see "Removing the housing front cover") .

Create a feed-through for the cable of the dosing pump (see installing a cable grommet). Feed the cable of the dosing pump through the
cable gland and connect it as described in "Relay configuration" to the relay defined under pH primary (default pH).

Close the cover. Make sure that the seal is firmly seated and that the clamps are fitted securely.
 As soon as you reconnect the Salt Relax POWER to the power supply and switch it on, the software will detect the pH option and display
the associated menus at the corresponding points.
5.5 Settings on the device
5.5.1 Set point pH
Setpoint for unidirectional pH regulation:
Entry of the setpoint for unidirectional pH regulation.
To select, select Set points with / and confirm with
Setpoint pH acid
The optimum pH value is pH 7.0 – pH 7.4.
When dosing with / pH Plus enter the setpoint 7, and when dosing
with pH Minus, enter the setpoint 7.4.
Setpoint for bidirectional pH regulation:
Entry of the setpoint for bidirectional pH regulation.
To set, select Set points with / and confirm with
Setpoint pH
The optimum pH value is pH 7.0 – pH 7.4.
Using / , enter 7 as pH low and 7.4 as pH high.
Please have all further settings in the software of the Salt Relax POWER made by a specialist technician as described in Service menu (parameter
"10 pH setpoint mode," "11 pH Al3 pump off time," "12 pH AL3 function“ and "13 pH relay activation delay").