3 Installation
5
3.1
Wall installation
Notes on installation:
The device must be mounted on a flat, vertical surface protected against moisture.
There must be adequate free space around the device to allow correct operation and maintenance of the device.
It must be possible to remove the front cover of the device.
A space of at least 20 cm below and to the side of the device is required for routing cables.
A wet room Schuko socket (two pin earthed plug) with continuous current is required at a distance of not more than 1.5 m.
All cables must be routed without kinks and chafing points.
Avoid exposure to direct sunlight, heat radiation, frost and moisture. Ensure adequate ventilation.
No live cables, contactors, electric motors etc. in the immediate vicinity.
The installation location should be as close as possible to that of the chlorine production cell (note cable length).
The Salt Relax POWER with the mounted holders can be used as a template for drilling by holding it up against the mounting location and
marking the position of the drill holes on the wall.
3.2
Electrical connection
The Salt Relax POWER has been designed and constructed according to the applicable regulations. It was carefully inspected before leaving the
factory and left the factory in a safe and technically flawless condition.
The equipment can only be operated safely if all of the instructions contained in this manual are followed.
The supply voltage for the device must not exceed 110 - 240V/60 Hz. The permissible operating temperature range is from 0 to 50
O
C, the permissible
humidity level 0-90 %.
As is standard practice for electrical connections, ensure that all plug-in connections and cable grommets are protected against water.
3.2.1
Supply via the filter control
If the Salt Relax POWER is activated via an external timer (e.g. filter control), it must be ensured that the circulating pump and the Salt Relax POWER
are precisely synchronised. The Salt Relax POWER must be switched off if there is no flow of water.
Make sure that the external timer (e.g. filter control) meets the performance requirements of the Salt Relax POWER!
Содержание NATURALLY SALT Salt Relax POWER
Страница 1: ...Salt Relax POWER Version 2 9 EN Operating and installation manual...
Страница 2: ......