Bay Networks Remote Annex 2000, Руководство по установке оборудования

Страница: 66 / 136

Remote Annex 2000 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-8
boot
The boot command requests the loading of appropriate Remote
Annex 2000 operating software from the preferred load host. The
command syntax is:
boot [–lv | filename]
The boot –l command is supported only if the self-boot option
(Flash) is installed.
Typing the letter q or -C interrupts the boot.
If you try to boot with a non-existent image file name, the
Annex will hang as it searches for the image. You must press
the
button to recover.
A successful boot disables the Console and the ROM monitor.
The boot command accepts a file name for the Remote Annex 2000’s
image. If the file name is not specified, boot displays the default file
name and prompts for one. If you do not provide a file name, or have
not defined one for the Remote Annex 2000, boot requests the default
file oper.56.enet. You can also enter a file name using the image
command.
The Remote Annex boots from the defined preferred load host
(UNIX/IP, Novell/IPX, or VAX VMS/MOP). If the preferred load
host is not defined or does not respond, the Remote Annex 2000
broadcasts on the Ethernet and loads from the first host
that responds.
To initiate loading, the Remote Annex 2000 sends a load request
message to the selected host. After receiving a response, the Remote
Annex 2000 loads its operational code to RAM memory. When
loading is complete, it transfers control to the newly-loaded program.
The Remote Annex 2000 displays a symbol on the console for each
data block received during the boot.
Control
Reset