9.3 Floor sealing.
Using the floor sealing tape supplied, seal the bottom
of the hotbox to the fireplace and hearth floor. Run
the tape over the centre bracket (See figure 18).
10. BURNER INSTALLATION
10.1 Burner and supply pipe installation.
1.
Refit the burner unit to the hotbox using the
two screws removed previously. The burner
securing points should be on the inside of the
hotbox as shown in figure 19.
2.
Connect the supply line to the appliance.
3.
If closed
,
open the isolating valve at the inlet
elbow.
4.
Turn on the gas supply and pressure check
the installation pipework for gas soundness. In
the United Kingdom check in accordance with the current edition of BS 6891. In the
Republic of Ireland refer to the current edition of I.S. 813 “Domestic gas installations”.
10.2.1 Lighting the burner.
1.
Depress the control knob and rotate it anticlockwise to the ‘pilot ignition’ position. A
'click' will be heard as the integral piezo operates. A spark should be seen between the
electrode and pilot tip.
2.
Turn the control knob clockwise to the 'OFF' position. Repeat this operation until a
flame appears at the pilot. There may be a delay before the pilot lights due to air being
purged from the system. When a flame appears at the pilot keep the control knob
depressed and hold the pilot ignition position for ten seconds. When the control knob is
released the pilot flame should remain lit.
Page 25
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 18. Floor sealing
Figure 19. Burner attachment points
