12. FASCIA AND FIREFRONT INSTALLATION
12.1 Fitting a firefront that has not been supplied with the fire.
!
A slotted firefront with a
minimum
free area as shown in figure 22 must always be
used.
!
For models supplied with a Baxi Fires Division firefront, the open area may differ
slightly from that stated in figure 22. In these cases the firefront will have been tested
with the fire and found to be satisfactory for use with the fire.
12.2 Fitting the Quantum fascia.
1.
Place the fascia on top of the plinth.
Be careful not to drag the fascia across
the top surface of the plinth as this will
scratch the plinth. Secure the fascia to the
plinth using the two ‘D’ screws supplied
(See Figure 23).
2.
Fit the fascia to the appliance by
locating the top to the upper hanging
bracket (Figure 24), then attaching it to
the body of the appliance using the two
‘C’ screws supplied (Figure 23).
3.
Fit the lower hanging trim to the fascia
(Figure 25).
Page 28
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 22. Firefront minimum open area requirements (The
firefront may differ from that shown)
Figure 23. Fitting Quantum, Mirage and
Urban fascia
