
15.5 To replace the burner.
(See figure 41).
1.
Remove the burner unit (See section 15.2).
2.
Support the elbow injector and unscrew the
injector nut.
3.
Remove the two screws from the burner clamping
plate (See figure 41).
4.
Lift the right hand side of the burner, slide it to
the right and lift clear
5.
Refit in reverse order.
15.6 To remove the main burner injector.
(See figure 42).
1.
Remove the burner (See section 15.5).
2.
Remove the burner clamping screw (See figure
42).
3.
Unscrew the injector from the burner.
4.
Refit in the reverse order.
15.7 To remove the appliance from the fireplace.
1.
Remove the burner unit (See section 15.2).
2.
Slacken the hexagonal adjusters on the cable
adjusters and unscrew the thumbscrews to release
the cables.
3.
Refit as described in the relevant installation sections.
Make sure gas soundness, sealing, spillage test and
performance are satisfactory.
15.8 To remove the Quantum, Mirage, Bolero and
Urban fascia.
1.
Remove the bottom front fascia.
2.
Remove the two screws securing the bottom of the
fascia to the sides of the hotbox (See figure 43).
3.
Carefully lift the fascia upward to clear the upper
retaining bracket on the hotbox. Pull the fascia clear and
place carefully aside.
4.
Refit in the reverse order. Make sure that the fascia is
properly located over the upper retaining bracket(s). See
section 12 of this manual for detailed fitting instructions.
Page 38
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 43. Removing the
fascia fixing screws
Figure 42. Main burner injector
removal
Figure 41. Removal of burner