After removal conduct the spillage check again.
The restrictor is packed flat with the appliance
and will require bending prior to fixing. Bend the
restrictor as shown in figure 10.
Fit the restrictor as shown in figure 11 using the
two ‘B’ screws provided.
8.4 Fitting the Quantum fascia hanging
bracket.
1.
Supplied in the loose parts pack is a fascia
hanging bracket ‘E’. Fit this to the top of the
hotbox using two of the ‘A’ screws supplied.
(See figure 12).
9. HOTBOX INSTALLATION
9.1 Method 1- Front fixing to fireplace surround
1.
Make sure that the fireplace front surround area is sound enough to take the wall
plugs and screws. If necessary, make sound with a suitable cement.
2.
Place the hotbox centrally in the fireplace in the position in which it is to be
permanently installed. If a concealed connection is being used, insert the hotbox into the
fireplace feeding the supply pipe through the pierced hole in the rear seal.
3.
Mark the fireplace front surround through the four fixing holes in the side flanges of
the hotbox (See figure 13).
4.
Remove the hotbox. Drill four holes in the fireplace front surround at the marked
positions using a no.12 masonry drill.
5.
Insert a wall plug ‘I’ into each hole.
Page 22
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 12. Quantum fascia bracket.
Figure 11. Fixing restrictor
Figure 10. Bending the restrictor
