Baur PD-TaD 80, Руководство пользователя, Страница: 63 / 74

PD-TaD 80 Faults and corrective measures
822-188-3 63 / 74
NOTICE
Damage to device due to improper handling
The user is liable for damages caused due to repairs.

Never take apart the device. This can lead to device damages. Inside the device
there are no components that could be serviced or repaired by the user.

Repairs must be carried out only by personnel trained and authorised by BAUR
15.1 Malfunction and error messages
When a fault or an error message occurs, proceed as follows:
1. Check the supply voltage, the connection cables and earth cable.
2. Check whether the fuses are working:

PD-TaD 80 integrated in the cable test van: at the mains and safety control unit or
the mains supply unit
Further information: User manual for the cable test van

PD-TaD 80 as a standalone system: in the Power Box
Further information: Chapter Power Box (PD-TaD 80 as a standalone system) (on
page 18)
3. Check whether the system is in the required operating state.
4. Restart the PC or laptop.
Start the BAUR system software and check whether the fault continues to occur.
5. If the fault occurs again, write down the error text and the procedure that caused the
error to occur.
6. Put the system out of operation and mark it accordingly.
7. Contact your nearest BAUR representative (http://www.baur.eu/baur-worldwide).
Further information on error messages can be found:

in the user manuals for the BAUR system software

in the user manual for the cable test van or the VLF HV
generator
15 F
AULTS AND CORRECTIVE MEASURES