Mounting
Instruction handbook
b maXX
(BM4-F-)AIO-XX (Analog IO module)
Document No.: 5.01045.08
35
6
4
Turn the twist lock beyond and beneath by 90°.
The twist locks now are standing horizontally.
5
Take the front panel cover towards the front off. Keep this cover.
6
Take the
BM4-F-AIO-XX
out of its transport packing. Avoid the contact with electronic
parts of the plug-in module.
7
Plug the
BM4-F-AIO-XX
module into the guide supports of the slot. The handle must
point to the same side as the other handles in this slot strip (here: right side).
8
Press with two fingers on the front panel until the
BM4-F-AIO-XX
module within the
device sensible latches tightly into the end position.
9
Turn the twist lock beyond and beneath by 90° into the vertical position (locking posi-
tion).
10
Connect cable of the
BM4-F-AIO-XX
module with the Sub-D connector.
11
Put the design cover on the device again.
Thus the mounting of the
BM4-F-AIO-XX
is completed.
NOTICE!
Note
electrostatic discharge
!
The
BM4-F-AIO-XX
contains ESD sensible parts.
Therefore:
m
Regard the described ESD procedures when handling the plug-in module.
m
Touch the plug-in module only at its handle.
NOTE
If you, within the scope of a repair of the
BM4-F-AIO-XX
, simply displace it by a sim-
ilar plug-in module, you can shorten the further operation, installation, commissioning
and so on. Then you simply must put on the connector to the plug-in module, put on
the design cover again and you can turn on the device again.
Содержание AIO Series
Страница 83: ......