Baumatic BCD901SS, Инструкция по эксплуатации

Страница: 40 / 48

40
o
The correct adjustment is obtained when the flame has a
length of about 3 – 4 mm.
o
For butane/propane gas, the adjusting screw must be tightly
screwed in.
o
Refit the control knob.
o
Make sure that the flame does not go out by quickly turning
from maximum flow to minimum flow. If it does then remove
the control knob and make further adjustments to the gas
flow, testing it again once the adjustment has been made.
o
IMPORTANT: On completion carry out a gas tightness
test.
Gas tap replacement
All work must be carried out by a GASSAFE
registered engineer.
IMPORTANT: Always isolate the cooker from the electricity
supply before changing the gas taps.
o
Remove all pan supports and burner heads.
o
Unscrew the burner fixing screws (A) (four for the triple crown
burner and two for all others) as shown in the diagram below:
o
Pull out the knobs.
o
Unscrew the six fixing screws (B) which lock the side profiles
and remove it.