PNEUMATIC ZEUS mod. 2009
page 2
January 2009
2.
IMPORTANT
Before installing ZEUS, it is necessary to set up the following facilities next to where it
will be installed:
1.
a water connection (tap with hose holder). ZEUS will be connected to the tap with
hose holder named WATER INLET
(fig. 1)
thanks to a rubber hose with a pressure
capacity of at least 10 ATM. (diameter of water inlet 8/13 mm) and which must be
fixed tightly with 2 hose clamps.
N.B.
before inserting the rubber hose into ZEUS
hose holder, exhaust a few litres of water in order to clean the conduit;
2.
a grounded outlet suitable to ZEUS power;
3.
a compressed air tube able to supply a constant pressure of at least 8/10 bar.
4.
N.B.
The blowing motor is three-phase. Should it work, but not blow, invert
two phases on the electric feeding.
3.
OPENING OF PACKAGE
1.
Open the box containing ZEUS from the upper side marked ALTO , take out the
instructions handbook and read it carefully.
2.
Remove ZEUS from the box and fix the support for clamps
(fig. 1)
.
4.
“STANDARD” & “STAND
-
BY” MODE
By turning on the main switch the machine is in
“stand
-
by”
mode. (red led on). This
mode allows access to the SET menu in order to set functions such as: language,
periodical maintenance warnings etc.
–
see point 6):
Electronic card in
stand-by
mode. If maintenance should be required
(filter cleaning, cover changing, …) a warning will inform you which
intervention is needed. The warning will disappear once the intervention
has been done and the RESET button has been pressed (see point 9).
By pressing the start button, the machine is in
“standard”
mode. This allows to set the
ironing functions (i.e. speed of motors, temperature of ironing board, iron functioning
etc.):
Electronic card in
standard
mode.
To temporarily turn off the machine you may press the start button: the machine will
go into stand-by mode and the red led will turn on. However, the electronic card will
continue to receive power from the mains supply.
At the end of each working day we suggest to always turn the machine off by
using the main switch (fig. 1).
WARNING:
the electronic card automatically performs a check of the software
installed. If an error or fault is found the
“safety” device blocks the electronic card and
does not allow normal functioning. “
SOFTWARE UPDATE NEEDED
” will be displayed.
Contact the Authorized Service Centre to update the software.
i
g
.
1
