PNEUMATIC ZEUS mod. 2009
page 8
January 2009
14.
ARMS AND CLAMPS PRESSURE ADJUSTMENT
It is possible to adjust the closing
pressure of the clamps and the traction
(opening) and return (closing) pressure of
the arms by using the special knobs. By
increasing the pressure, the force exerted
on the garment by clamps and arms
increases,
too.
On
the
relative
manometers, you can see the chosen
pressure
(fig.
4)
.
Make
these
adjustments in such a way that the
garment does not slip away from the
clamps and it is simultaneously well
stretched by the arms.
N.B.:
should it happen that at the end of the cycle the arms do not close, increase
their closing pressure. On the other hand, should they close down too quickly,
just decrease the pressure;
N.B.:
do not increase the pressure of the clamps too much; a high pressure might
cause hand injuries if accidentally pressed by the clamps. Should it occur,
push immediately on the opening button
(fig. 2)
.
15.
ADJUSTMENT OF OPENING AND CLOSING SPEED OF ARMS AND CLAMPS
It is possible to adjust the opening and closing speed of arms and clamps by using the
special screw on the four little pistons and following these instructions
(fig. 5)
:
LITTLE PISTONS ON CLAMPS
SCREW A
: turn anticlockwise to increase the closing speed
of the clamps, clockwise to decrease it.
SCREW B
: turn anticlockwise to increase the opening speed
of the clamps, clockwise to decrease it.
LITTLE PISTONS ON ARMS
SCREW A
: turn anticlockwise to increase the closing speed
of the arms, clockwise to decrease it.
SCREW B
: turn anticlockwise to increase the opening speed
of the arms, clockwise to decrease it.
MANOMETER FOR
ARM TRACTION
ADJUSTMENT
FOR ARM RETURN
MANOMETER
FOR ARM RETURN
ADJUSTMENT
FOR CLAMPS
CLOSING
MANOMETER
FOR CLAMPS CLOSING
Fig. 4
A
B
Fig. 5
