Barbara 31 mod. 2010
10
2016
3.
OPENING OF PACKAGE
1.
Open the box containing BARBARA 31 from the side marked with ALTO , take out
the instruction manual and read it carefully.
2.
Remove BARBARA 31 from the box, insert the cable support deep into the special
hole (fig. 1) placed on the back side of the generator.
3.
Fix the spring to the support hook, avoiding entwining (fig. 1).
4.
Place the iron on the rubber rest supplied with the machine (fig. 1).
4.
CONNECTION AND STARTING
With BARBARA 31 switched off and disconnected plug:
1.
Unscrew the safety valve plug of BARBARA 31 (fig. 1), fill the boiler with water to
the desired level (we suggest not to exceed MAX level marked in the level glass -
fig. 2). Take the plug by the plastic part and screw it again: do not tighten too
much or its gasket might get spoilt (see section 7).
N.B.: make sure the exhaust tap of the boiler is closed (fig. 7).
2.
Insert the plug into a 230 V 16 A socket.
3.
In case the boiler is too much filled,
the iron might leak water. If this is the
case, switch off the machine, unscrew the plug a bit, let all the steam come out of
the boiler and wait until the water and the boiler are cold. At this point turn the
exhaust tap so that the excess water flows out (see section 8).
4.
Switch on the boiler (fig. 2 C). Five minutes later switch on the iron (fig. 2 D) and
adjust the thermostat (fig. 4
) on “cotton”.
5.
Wait for the boiler lamp to switch off (fig. 2 A). Seize the iron by cork handle and
press the micro-switch of the iron (fig. 5) 4 or 5 times, so that steam comes out.
It is important to make sure it is a saturated steam (by pressing the micro-switch
with the iron pointed towards the floor). It is possible to adjust steam flux by
turning the hand-wheel placed on the solenoid valve (fig. 1). Now everything is
ready for ironing. During ironing operation, the boiler lamp switches on and off
signalling that the machine is working properly (fig. 2 A).
Fig. 3
Fig. 2
