Bartec PBTC-200, Руководство по эксплуатации и установке

Страница: 7 / 48

Operation and Installation Manual PBTC-200
21-54C3-7D0001/-
04/2021-EHT-441168 Notice: Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
Page 5 / 45
HTSB-Heating system
IECEx SIR 16.0035
Ex e IIC T2, T3 Gb
Ex tb IIIC T200°C ,T300°C Db
SIRA 16 ATEX 3099
II 2G Ex e IIC T2, T3 Gb
II 2D Ex tb IIIC T200°C ,T300°C Db
2.3 Reasonably foreseeable Misuse
The following activities are a misuse of the product and are not allowed:

Use of the junction box with thermostat module for purposes other than those described in the intended use

Don't observe the maximum permissible heating circuit length, the data sheet of the heating cable type or the Design
Guide

Installation, commissioning, operation, maintenance or disposal by unauthorised or unqualified personnel

Work on live parts or circuits without switching off the junction box with thermostat module or the system

Change, removal or obscuring of signs, notices or warnings

Use of system components that are not approved for use

Commissioning of damaged or faulty system components

Technical modification of the junction box with thermostat module

Non-compliance with the approval and marking of the heating system
The operation of the Electronic Thermostat Module is also considered as misuse

Without properly designed overcurrent protection device

With not approved heating cable or more than one heating cable

Outside defined maintenance and ambient temperature

With unsealed or unsuitable CAK seal

no replacement of the CAK seal after dismantling the heating cable
2.4 Personal Qualification
The junction box with thermostat module may only be handled by qualified personnel in all phases of its life.
The junction box with thermostat module may only be transported by instructed and qualified personnel with special knowledge of
transport.
The system design, installation/assembly, commissioning, operation, maintenance, decommissioning and re-commissioning of the
junction box with thermostat module may only be carried out by trained, instructed and qualified personnel with specific expertise in
the electrical engineering.
Disposal of the junction box with thermostat module may only be carried out by trained, instructed and qualified personnel with
specialist knowledge of disposal.
For system planning, installation/assembly, commissioning, operation and maintenance/servicing, the requirements for personnel
qualification according to DIN/EN 60079-14 must also be observed.