Barrus SHIRE 14 30 WB, Руководство пользователя

Страница: 21 / 40

RDG603A9 - Issue 1 - Shire 14 Workboat Owners Manual 30, 40, 50 Page 21 of 40
SECTION 5 - Service Procedure
1. Engine Oil and Filter Change
CAUTION:
WEAR DISPOSABLE GLOVES AND BEWARE OF HOT OIL AND ENGINE BLOCK.
REMOVE THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.

Change the engine oil while the engine is still hot.

Remove the blanking plug in the sump pump spout. [6mm Allen key] Note (if there is
an optional gearbox oil drain pump) the engine sump is the pump mounted adjacent
to the starter motor.

Place a plastic tube over the spout and into a container. Operate the pump handle to
empty the sump. (Remember to refit the blanking plug afterwards).

Place a drip tray under the engine to catch the small amount of oil that will escape
from the oil filter. Using a strap type oil filter removal tool (supplied), slacken the filter
from the engine block in an anti-clockwise direction, remove the tool and spin off the
filter.

Lightly oil the new filter O-ring seal and install the filter onto the engine. Spin it on in a
clockwise direction and finally tighten by hand only as firmly as you can.

Refill the sump using the oil filler cap in the rocker cover on top of the engine.

Oil level should be to the top mark on the dipstick.

Run the engine for 5 minutes to fully circulate the oil, and check for leaks, stop the
engine. Wait 5 minutes before checking the oil level with the dipstick and top up if
required.

Do not overfill with oil above the maximum level marker as this may cause damage to
the internal components of the engine.