Barrus SHIRE 14 30 WB, Руководство пользователя

Страница: 26 / 40

RDG603A9 - Issue 1 - Shire 14 Workboat Owners Manual 30, 40, 50 Page 26 of 40
6. Bleeding the Fuel System.

Ensure the fuel tank is at least ¾ full prior to undertaking this procedure.

See Fuel paragraph, Section 3, in Yanmar Engine Operation Manual
.
7. Cooling System
CAUTION:
DO NOT CHECK THE COOLANT LEVEL WHEN THE ENGINE IS HOT.
REMOVE THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.

To check the coolant level, ensure that the engine has been shut down for at least
half an hour.

The coolant level can be checked visually and should between the two level marks
moulded on the front of the white, plastic expansion tank.

If required, top up the level with coolant (50% clean tap water and 50% ethylene
glycol based anti-freeze) through the expansion tank filler cap.

Do not use water only to top up as this weakens the coolant mix, reducing the level of
frost protection and anti-corrosion protection of the coolant.
8. Belt Adjustment

Depress the longest run of the drive belt to be checked. If the travel exceeds 15
–20
mm using hard finger pressure, the belt needs re-tensioning.

Loosen the upper adjuster bolts on the alternator, and the lower mounting pivot nut
and bolt, pull out using hand pressure.

Pull the alternator away from the engine to tighten the belt.

Hold the alternator in position and re-tighten all the bolts.
CAUTION:
WEAR DISPOSABLE GLOVES.
REMOVE THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.
CAUTION:
REMOVE THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.