![background image](http://html1.mh-extra.com/html/barco/r9000893/r9000893_installation-manual_4213998016.webp)
Projector set-up
5-2
5975857 BARCOGRAPHICS 1208s 220197
Setting the projector address
The projector's address may be set to any value between 0 and 255.
When the address is set, the projector can be controlled now by :
❒
RCU for addresses between 0 and 9;
❒
IBM PC (or compatible) or Apple MAC for addresses between 0 and
255.
0
9
Addressable with RCU
Addressable with PC, MAC
or workstation
255
1
128
2
64
3
32
4
16
5
8
6
4
7
2
8
1
Setting the address is a hardware SET-UP of your projector which
must be done during installation. Use the 8 DIP switches provided on
the controller unit.
Each DIP switch has its own decimal value. The sum of the values
associated to those DIP switches gives the address. As shown in the
table, if Switch No. 1 is set to ON, it represents a decimal value of 128,
Switch No.2 for 64, Switch No.3 for 32, and so forth.
In the given example, the projector address is set to 202 :
DIP switch No.
: 1 2 3 4 5 6 7 8
Position ON/OFF : 1 1 0 0 1 0 1 0
Sum : 1x128 + 1x64 + 0x32 + 0x16 + 1x8 + 0x4 + 1x2 + 0x1 = 202
Note :
when the address button on the RCU is pressed, the projector will
display its own address on the screen. Once the address button is
pressed, to continue using your RCU, it is necessary to enter an
address, even when the displayed address is correct. Use the
numeric keys to enter the address.
1
2
3
4
5
6
7
8
0
1
OFF ON
Switch No Value
PROJECTOR
ADDRESS
001