AC power connection
6-3
5975857 BARCOGRAPHICS 1208s 220197
Cover plate (side view)
Top view marked area
cabinet
metal bottom plate
inside projector
Fuses
Warning !
For continued protection against fire hazard :
❒
Replace with the same type of fuse.
❒
Refer replacement to qualified service personnel.
AC power Fuses
Order Number
230 Vac T6.3A/250V (2x)
R314145
120 Vac
T10A/250V (2x)
R314154
hm
ON
T 1
EO)
PROJECTOR MODE
POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ON
OFF
GREEN : operational
RED : stand-by
352
Switching on the projector
Push the power (mains) switch located on the back panel of the
projector to switch the projector ON and OFF :
❒
if the switch is pressed in
: ON
❒
if the switch is Not pressed in : OFF
The projector can be started up in the 'operational mode' (image
displayed) or in the 'stand-by mode', depending on the position of the
'power-up' DIP switch on the controller unit (see p.5-2). This DIP
switch is set during installation by a qualified technician. If you want
to change this start up mode, call a qualified technician.
Power indication lamp :
OFF
: no power
Green : projector in operational mode
Red
: projector in stand-by mode
When switching on the projector, with the power switch or via the
stand-by key, the projector can start up in two ways if the "CRT run
in cycle" option is switched OFF :
❒
a full white image (projector warm up) or
❒
immediately image display.
The way of starting up can be set in the service mode.
