![background image](http://html1.mh-extra.com/html/barco/r9000893/r9000893_installation-manual_4213998014.webp)
Installation set-up
4-3
5975857 BARCOGRAPHICS 1208s 220197
Horizontal Scan Switches
Three switches are used, one for each CRT. When changing
the horizontal scan, insure that all three switches are set in the
same position. See positions of the switches for the corre-
sponding projector configuration.
Vertical Scan Switch
One switch for the three CRT's is used. See position of the
switch for the corresponding projector configuration.
After setting the scan switches, close all the metal protection plates
and secure them with the retaining screws.
Close the top cover and reconnect the power cord to the wall outlet.
Note :
Switching over from Floor to Ceiling or vice versa requires a complete
readjustment of picture geometry and convergence.
To check the current position of the scan switches, proceed as follows:
Attention : this check procedure can only be done after power (mains)
connection. So, first continue with the projector set-up and the
connections and then return to this checking procedure.
Switch on the BARCOGRAPHICS1208s and press ADJUST to start
up the adjustment mode. Select 'SERVICE' by pushing the control
stick forward or backward and press ENTER. The service menu will
be displayed. Select 'IDENTIFICATION' and press ENTER. The
screen gives information about the projectors configuration. All
projectors leave the factory set for a ceiling/front configuration.
Follow next procedure to check the configuration :
➊
switch on the projector;
➋
the projector starts up on the last selected source;
➌
press ADJUST;
➍
highlight 'SERVICE' by pushing the control stick forward or back-
ward and press
ENTER : the 'SERVICE MODE MENU' will be
displayed;
➎
highlight 'IDENTIFICATION' by pushing the control stick forward or
backward and press ENTER.
The projector will display the 'IDENTIFICATION SCREEN'.
This screen gives the current information about the projector configu-
ration in the line entitled 'config'.
B
G
R
Horizontal
deflection switches
Vertical
deflection switch
Projector configurations (Switch settings)
Front-ceiling
R
G
B
Front-table
Rear-ceiling
Rear-table
R
G
B
R
G
B
R
G
B
pressed
pressed
pressed
pressed
not pressed
not pressed
not pressed
not pressed
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
GRAPHICS 1208S
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
DYNAMIC ASTIGMATISM
MORE...
Select with
é
or
ê
then <ENTER>;
<EXIT> to return.
ADJUSTMENT MODE
Select a path from
below:
Select with or
then <ENTER>
<EXIT> to return
source 1
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS