Projector set-up
5-3
5975857 BARCOGRAPHICS 1208s 220197
1
2
3
4
5
6
7
8
ON
OFF
Power-up mode
OFF ON
Power-up mode
The projector can start up in two different modes. The start up mode
is determined by the position of DIP Switch No. 4 of another set of 8
DIP switches on the controller unit (one set of 8 switches are used for
projector address setting).
Position of the DIP Switch No. 4 (power up mode) :
ON : operational mode
OFF : stand-by mode
Source 2
Fh= 15.6 kHz
Fv= 50 Hz
❒
❒
Operational mode
When the power switch on the rear of the projector is pressed, the
projector displays the last selected source if available, otherwise it
remains on that source number until the source becomes available.
The on screen indication is only available when the "Text" function is
set to "ON".
❒
❒
Stand-By mode
When the power switch on the rear of the projector is pressed, the
projector starts up in the stand-by mode. The stand-by key on the RCU
is used to turn the projector ON and OFF.
Position of DIP switches and baud rate codes :
Baud Rate for communication with a
computer
The communication speed between the projector and the computer
has 8 possible settings. With DIP Switch No. 6, No.7 and No.8 of the
8 DIP switches on the controller unit, labelled as ‘Baud rate code
(sum)’, it is possible to select the baud rate (communication speed).
Each DIP switch has its own decimal value. The sum of the values
associated to those DIP switches gives the baud rate code. Each
baud rate code corresponds an communication speed.
baud rate code speed
0
110
1
150
2
300
3
600
4
1200
5
2400
6
4800
7
9600
More information about computer communication with the BARCO-
GRAPHICS 1208s is available in the Projector Control Software
manual.
1
2
3
4
5
6
7
8
OFF ON
0
1
Baud rate
DIP switches
4
2
1
