Barco MES ACURAS HEAD, Руководство пользователя и инструкция по установке

Страница: 111 / 131

10. Operating AutoGeometry
Image 10-5
Start Capture: button
An AutoGeometry dialog will appear.
Image 10-6
AutoGeometry: dialog
6. In this dialog
- click Selected Group to run the AutoGeometry capture process to all projectors of the selected group.
- click Selected Projector to run the AutoGeometry capture process to the selected projector(s) of the selected group.
- click Cancel to abort the AutoGeometry capture process.
Note: Pressing the Interrupt button will stop the AutoGeometry Capture process. The Gimbal will come back to its original
position.
The following con fi rmation dialog will appear.
Image 10-7
Note: All the unselected projector(s) and the projector(s) on which the AutoGeometry capture process is not running go to
pause state.
Note: If AutoGeometry positions were de fi ned for different head locations, the user will be prompted to move the Auto Alignment
Head to the appropriate locations physically during the AutoGeometry capture process.
A message appearing in the feedback section shows the progress information. It may take several minutes to complete the
AutoGeometry capture operation for each projector channel or for the HUD projector.
Image 10-8
AutoGeometry process in progress
R59770509 MES ACURAS HEAD - AUTO ALIGNMENT HEAD 24/11/2010 103