4. Daily operation
4. DAILY OPERATION
4.1
On/Off switching
To switch on/off your display:
1. Power on/off your display using the mains switch located on the back of the display.
While your display is on, press and hold the stand-by key for approximately 1 second
to put the display in the stand-by mode.
While your display is in stand-by mode, press and hold the stand-by key for approxi-
mately 1 second to activate the display.
4.2
Power mode LED
About the power mode LED
The behavior of the power LED shows the status of the unit:
OFF
Hard power OFF (power unplugged or switched off through rocker switch)
Amber slow blinking
Soft power OFF (switched off by using the stand-by key ( ))
Full amber
Display is in power save mode (backlight and LCD off)
Green/amber blinking Searching for signal
Note: When Power save mode is enabled, the display will automatically go into
power save mode after 10 seconds of searching without signal.
Full green
Display has a valid input signal.
4.3
OSD menu activation
To activate the OSD menu
Press the
key on the display.
As a result, the OSD main menu comes up in the bottom right corner of the screen. If no further actions
are taken within the following 30 seconds, the OSD menu will disappear again.
If after pressing the
key, the
OSD lock
window appears then this means that the OSD lock has been
enabled. Please refer to "OSD menu locking/unlocking", page 20for more information and instructions to
unlock the OSD menu.
The time-out of the OSD menu automatic close function can be adjusted or disabled in
the OSD menu (
OSD Time-out
).
K5902133 (451920612482) MDSC-8255 23/11/2017
17
