Barco Matrix-PRO HD-SDI, Инструкция по установке и эксплуатации

Страница: 31 / 52

MatrixPRO
TM
16x Series
Manual #26-0301100-00/ Revision A
25
1) Click on the Start button and select Run.
2) Click on the Browse button and locate the
"MatrixPRO16x_Rev#####_###.exe" file on your hard drive.
3)
Double click on this file and then click OK to start the installation process.
4) Follow the on screen instructions to complete the install.
5.7 PREPARING TO UPGRADE THE MATRIXPRO
TM
16X
1) Plug the DB-25 male connector into the port labeled “RS-232/485 IN” on the
back of the MatrixPRO unit.
2) Make sure the other end of the cable is attached to the available COM port on
the back of the computer performing the upgrade.
3)
Turn the MatrixPRO ON or do a power cycle if it was previously powered on
and wait for it to boot.
5.8 STARTING THE MATRIXPRO
TM
FLASH FILE LOADER UTILITY
After the files have been installed the MatrixPRO
TM
Flash File Loader can be selected
to run.
1) Click on the Start button and select Programs.
2) Find the Folsom Research folder and select MatrixPRO
TM
Flash File Loader.
5.9 VERIFYING COMMUNICATIONS BETWEEN THE COMPUTER AND
MATRIXPRO UNIT
1) In the loader program, click in the Black Terminal Window area.
2) If communications is established, pressing the ENTER key on the keyboard
will result in the terminal window displaying various messages and finally with
the system prompt “#” displayed. If nothing occurs when ENTER key is
pressed, it is possible that serial port communication was not established. If
this is true, click on the RS232 Config Menu and select the COM Port the unit
is connected to. In the CONFIG SERIAL submenu and verify the following:
ECHO = ON
BAUD RATE = 57.6K
DATA BIT = 8
STOP BIT = 1
PARITY = NONE
HANDSHAKING = ON
If any of the communication parameters are changed within the loader, it is
recommended that the MatrixPRO
TM
unit be powered cycled and the verification
process started over.