Barco Event Master E2 Lite, Руководство пользователя

Страница: 36 / 330

R5909934 /00 E2 Lite and EC-40 36
Image 4-4: E2 Lite rear panel
1 AC connectors
2
RJ-45 connector for 10/100 BaseT Ethernet
communications
3
Genlock Input BNC with passive Loop-through
4 Input cards (DVI, HDMI/DP, and Tri-Combo)
5
Output cards (HDMI)
6
Multiviewer (HDMI)
AC connectors
The Event Master E2 Lite is equipped with two redundant power supplies. During normal operation the load is
shared equally by both supplies. If one supply fails, the second carries the whole load. Two AC connectors are
provided to connect the E2 Lite video processor to your facility
’ s AC power source through the supplied power
cords.
Input Power Specification: 100-240 VAC, 47-63 Hz
On each power supply there are 3 LED lights that provide status information as follows:
• DC Output Power LED: when Green, the supply is outputting valid DC power.
• Status LED: when amber indicates that an error has occurred.
• AC Input Power LED: when green it indicates that the supply is connected to a valid AC power.
Therefore, during normal operating conditions, the input AC and Output DC LEDs will turn green.
The power supplies are installed upside down in the E2 Lite video processor, so the silk-screen
markings will also appear upside down.
Ethernet port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with the Event Master series
processor. The port is used for running the Web Interface.
The Ethernet connector is compatible with:
• Standard RJ-45 Ethernet cables
• Neutrik EtherCon® series cables
For pinout details, refer to the section dedicated to the pinout in Appendix A, “ Standard connector pinouts ” ,
page 296.
Genlock Input BNC (with passive Loop-through)
The Genlock input supports analog NTSC and PAL Blackburst, as well as HD tri-level sync signals, per
SMPTE 274M and SMPTE 296M. The passive loop-through connector passes the Genlock signal to another
device downstream of the Event Master series processor. The Loop-through output will continue to function
even when the device is turned off. When the device is genlocked and the lock source is lost, the output of the
unit will automatically switch to
“ free-run ” state without any discernible “ glitching ” on the output display device.
As the loop-thru is passive a 75Ohm termination is necessary for stable operation.
Hardware orientation